ASSEMBLY STEPS TO A COMPUTER

materia.- Ingles

Step 1 - Installing the motherboard : The motherboard has perforations that coincide with small posts that are subject to the cabinet , the card matching the holes and fixed with screws is spliced ​​.

Step 2. Installing the processor : the main card is taken and is prepared to insert the components that go directly into it. The side supports are fixed to the card base , placing the pins in position.

Step 3. Microprocessor fan : Once you put the fan, the fan power cable correct pin connecting plate .

Step 4. Installing RAM : The slats are inserted in DIMM RAM banks and fixed with the side latches . The number of slots can vary by manufacturer and model of the main board. In this case , the card has three slots and being inserted only 64MB DIMM .

Step 5. Installing video card : Installing cards in expansion slots , is always done in the same way : first inserted to find the correct position and then press heavily on them. Video cards can be of type ISA , PCI or AGP .

Step 6. Installing the audio card : audio cards can be type ISA or PCI . After identifying the correct type, the right place is positioned and then pressed on them.

Step 7. Installing the modem card : these cards can also be ISA or PCI , to insert , the same procedure is performed as in the previous cases.

Step 8. Attaching the floppy : To install this device known as drive or floppy disk , the cover is usually found in front, in the middle of the cabinet is removed. The unit is inserted through the rectangular conduit to match entries drive screws with the chassis holes for fixing using screws .

Step 9. Attaching the Hard Drive: This data storage device is placed on the inside of the cabinet, in the corresponding bay. It is matched holes and secured with screws.

Step 10. Replacing the Power Supply: Mount the power supply in the right rear of the housing is open. A mounted once was screwed.

Step 11. Connector Motherboard Sound: The front of this computer comes with 2 USB and 2 audio connectors (speaker and microphone), we have a cable to the USB connectors and one for audio connectors. These cables connect to the respective connectors on the motherboar

Step 12. Connector LEDs: Now connect the power of the LEDs on the front of the computer, this computer have 3 LEDs, are: 

-power LED - light on the computer

- HDD LED - Light computer processing

- SW led - Computer Power Button

These connectors are located at different positions.